Yes, I’ve started a YouTube channel.

My first post is about RMNoise, an AI filter, used to remove noise from SSB voice or CW radio signals. Noramly, audio is connected into and outo of a physical radio. I’m using Thetis radio software connected to a Hermes-Lite 2+. To connect Thetis to RMNoise I’m using Voice Meter Potato to create virtual audio cables to “wire” these together.

Thetis’s Input is connected to my microphone (Focusite). Thetis Output goes to CABLE-B’s Input. You should Enable VAC 1.

In RMNoise, the INPUT DEVICE: shoud come from CABLE-A Output. RMNoise’s OUTPUT DEVICE should go the the Voicemetere Input.

You’ll see this under the first of the three center sliders. I’ve then selected to the A1 output that is connected to my desk speakers. Notice I’ve also select A4 that is connected to my Headphones.

More to come about “wireing” Thetis.

W5TSU